The Hub

Hi all! I am new here, and really excited to be a part of the community. I am starting a new build, a 6 string semi hollow carved top with Tremolo bridge and Piezo. I'd appreciate some input to choose the best system out there. I haven't used/fixed/installed a tremolo with piezo bridge lately. I am open to hearing if you have come across something lately and felt impressed by it. It's going to be a workhorse guitar for a touring musician.…

Hi friends, I was at a colleague's shop this morning. He’s a pretty well-known builder. A customer has asked for names (several… grandchildren, you know) being inlayed in abalone in a fingerboard and he’s feeling out of his depth for this task. I have volunteered to help find a colleague who'd be willing to do it. Anyone interested in doing this? Any recommendations for a talented colleague? Thanks friends.

https://reverb.com/news/take-a-photo-tour-of-the-1904-harmony-instrument-factory?

When using epoxy (either silvertip or epoxy), I try to sand back the epoxy on the surface and only leave it in the pores. I'll start the process with sanding to 320g or so then using an air compressor to blow out the pores. The challenge that I run into is opening new pores in the process. I use a block of wood and long strokes in an attempt to avoid uneven sanding. Ultimately I'll get a good pore fill but I tend to apply several coats…

Hello, I just received an unfinished, slotted but not fretted maple neck from Warmoth. I believe standard practice is to fret then finish but I’m curious if it might be better finish before fretting? I understand one would want to prevent finish from entering the slots. I’m and going to use tru oil and do a light finish, maybe three or four light coats. Thoughts for this beginner? Dave

I've built a number of classical guitars with an adjustable neck and they seem to gather quite a bit of interest, so i'm currently in the process of looking to refine the design and build. It's quite a simple construction where the neck is held together by string tension and hangs on a pivot. I developed a 3d printed "socket" which acts as the interface between the body and the guitar and allows for some fine tuning of the alignment of t…