The Hub

I’ve got a client requesting a weight reduction on his Kurt Cobain Jaguar My approach would be in 3 steps see how much I can route down the existing cavities (might not be a lot of weight loss) route under the pickguard without compromising the instruments integrity if additional weight loss is required, drill into the body with airline drill bits to gain a few more grams current total weight all including 4.2kg Any advice is welcomed 🙏🙏🙏

I was approached by a local music venue about finishing over the signatures on this Dean guitar. I have finished over signatures before, but never an entire guitar. The main challenges, as I see it, with this endeavor is prepping the existing finish. Cleaning the existing finish without disturbing the signatures will be time consuming enough, but abraiding/sanding the finish will be cost prohibitive. I have already experimented on a test…

What’s the best way to make stark white ABS binding resemble 60 year old celluloid?

Looking to get a custom fingerboard slotted, radiused and cut for block inlays, preferably in Canada. Any leads much appreciated! 🙏

good evening to all. This one showed up on the marketplace. I'm wondering if its too much to chew for me at this time. Is it a very difficult repair? Is it worthwhile pursuing? It's another $25 crash test dummy. Please, don't hold back. I can take it.

@member hipped me to the fact that Steve Gilchirst has some really nice work detailed in his restoration archives. I think you should check it out. BTW he is super busy, so don't wear him out with emails.

Hey all, I have been working with the work station for a few months now. I love it. I found a few little things that have helped me. 1. A mic stand to support the main beam. I bought the Total Vise version and it didn't work as well. 2. Rockler Bench Cookies as rear cross member supports. They have the correct 5/16-18 inserts in them and screw on easily. Now the thread rod has a sort of hi/low setting by just flipping it for acoustic or…

Greetings Wise Elders and fellow seekers of the Looth Group! I hope you're all keeping well. I humbly beseech thee for thine sage wisdom and experience. I purchased a 1971 Hagstrom Swede. This guitar was basically put in a case and then forgotten about for a few decades. I felt sorry for the old man and have taken it in as a stray / project. I would like to get it playing again. There are many scars on this guitar, I have looked for as…

Some of you might enjoy this - a full recent guitar bouzouki build. It's about 35 mins long. Plenty of woodworking tips in there for the eagle eyed. Give it a watch, the tunes are great. Nigel

We just ordered the StewMac buffer. Looking for ideas/photos for a hood(s) to remove all the particles flying off. We have a 4 inch 1250 cfm dust collection system. Thanks for any input. Tom K

I am a retired dentist. One saying we had was, “You can’t fix what you can’t see.” And another was, “The day you start working with magnification will be the best and worst day of your practice.” The worst because you will see what you have been missing, and the best because you will never miss it again. So even though I have my Dan E. Model visor loupes, and my retired dental loupes on throughout the day, sometimes, it’s not enough. I pi…

Hey folks! I picked up a neck relief gauge from Doug in one of the earlier batches, maybe the introductory run? Some of the small feet caps that thread onto the moving legs of the tool have cracked, broken, or become worn down. I contacted StewMac about purchasing replacement parts, but they don't sell subparts for the relief gauge and otherwise won't help me. They appear 3D printed, so I was wondering if anyone with the means to print s…