-
Quikwood and Titebond?
Doing some repair work and I am missing original wood and adding new wood back in would be extremely difficult. I’ve had success using Quikwood as a filler in the past and finished over it with no issue. In this case I would need to add Quikwood to fill in a void and then use Titebond to glue on a veneer over that. The glue surface would be about 25% Quikwood and 75% actual wood.
Before I do this, any issues with Titebond adhering to Quikwood? Or any wood filler I guess? Thanks!
-
7 Replies
-
I like the Quick Wood product, which is actually just epoxy putty, but I would guess Titebond isn’t going to work really well on it. I do veneer over it all the time with Loctite Gel CA from Homedepot. Do you have a pic of the affliction ?
-
This headstock break was previously sanded and uneven. My guess is whoever did this previously did not use a sanding block. As a result, the left side (as you look down from the top of the headstock) has a dip in it from just after where the nut would sit that extends about 2.5″ up towards the tip of the headstock until it levels out again. My thought was to put some Quikwood in there as it would easily adapt to those odd contours and could be sanded back quickly to level. From there I would then slap a new veneer on w/ Titebond and cover up all that ugly stuff.
-
Since you’re dealing with a compromised neck, I would probably skip the quickwood and actually laminate some veneer wood on there with clamping pressure and Titebond. You can layer more than one and then sand it down. It will strengthen the headstock a little too.
woodcraft.com
Woodcraft Woodshop Wood Veneer - 4-1/2" to 6-1/2" W - 3 Square Foot Pack
High-quality, real wood veneers from around the world, packaged in a convenient size that won't break your budget! Each pack contains 3 square feet of unbacked cherry wood veneer. Each 2/83" thick sheet measures 12" in length and 4-1/2" to … Continue reading
-
-
-
Thank you. That makes sense. I have peghead veneer that is a bit too thick to bend into there but those thin ones you posted would work.
-
I was also going to add that I like to use green foam insulation backed with 1/2″ mdf for a project like this. When you put the clamps to it, the green foam will conform to the irregular shape.
https://www.lowes.com/pd/GreenGuard-GreenGuard-LG-1-2-x-4-x8-XPS-Insulation-Board/5001939677
lowes.com
Kingspan Insulation R-2.8, 0.5-in x 4-ft x 8-ft Unfaced Foam Board Insulation Lowes.com
Shop Kingspan Insulation R-2.8, 0.5-in x 4-ft x 8-ft Unfaced Foam Board Insulation in the Board Insulation department at Lowe's.com. For use as general purpose insulation for roofing, wall, and foundation applications requiring a minimum compressive strength of 25 psi. … Continue reading
-
-
I’m assuming you put foam side down onto the surface with the veneers? Interesting move. I like it. Thank you.
-
Yep, it squishes right down to the contour.
-
Log in to reply.