-
Washburn WCG20-SCE-0 Trussrod nut
I have a Washburn WCG20-SCE-0 for a setup and can’t figure out what trussrod wrench to use. The trussrod nut is buried DEEP in the neck block so I can’t see it and and none of my wrenches will reach or grab it.
Anyone know??
-
2 Replies
-
So, I have a set of hex wrenches that have the bend cut off. I then attach an appropriate length 1/4″ socket wrench extension with appropriate socket to match size of whatever hex size I’m using. If it’s a mystery, I just start trying different sizes until I find the right size. 1/4″ drive socket wrench allows for room to maneuver. Same use if it’s a standard nut. I then use thin wall, straight wall, 8 point sockets…Why they still put nuts in end blocks boggles the mind……..
-
Hi Neil,
It would be unusual for an acoustic with the truss rod adjusting nut access at the sound-hole in an import to use anything other than an Allen Key to adjust. There are of course exceptions. Do you have a full set of long L-shaped Allen Key (sometimes referred to Hex Key) wrenches, both metric and SAE?
Log in to reply.