Feed

Yea we would just want to put a slight gap in-between them, say .2mm, could even have some support materials in the middle for easy separation

I’ve got a parametric angled shim for fusion . Been meaning to upload to loothprint, I’ll try and do that this weekend

Good call, I expect that will eliminate the layer lines to make the angle.

I will try that, and once improved, will do other degrees as well.

One thing you might try is changing the orientation to have it on the side. You might print it as a block of 5 so it self supports and then split after. I bet @patreon_41670846 might know how to do that.

Man I feel like I’ve done more of these than I care to remember. Most come together great, others, meh.

The first thing I do is bag it up and humidify it really well for a week or so. This will swell the back closer to its original shape. The back shrinkage over the last 100 years is definitely a contributing factor. Then I have two cauls; one…

Read more

I use PU (polyurethane) “leather” desk pads

Here’s the original post I did about them:

https://www.instagram.com/p/CLn0l67sgF7/?igsh=b2JiZHh5MWQyN2x2

instagram.com

Guitar Specialist on Instagram: "I Hate Carpet!!! Today's shop tip is brought to you by a question from Grace @guelphguitarrepair. A couple of others have asked about this as well so I thought it would make a good shop tip. Grace asked about the top guard she noticed in the double hammer fretting video I posted. I'll start by repeating, I hate carpet. I used to cover the benches in our old shops with carpet as many of us do to have a soft bed for guitars to rest on while working on them. I've always hated how they trap everything. Wood dust, feet dust, glue, dirt ... you get the idea. No amount of vacuuming can pick up all the fret dust we generate. So when we moved into the new shop with our wonderful new benches I searched for some alternative. I struck gold. I found these "PU leather" desk pads that can be bought pretty inexpensively. They're the perfect softness and thickness to protect the guitar from hard benches. We spend an inordinate amount of time and effort protecting our customer's guitars from us. As soon as we got some for the benchtops I realized they were also perfect for lots of other uses. They're easy to cut into any shape and make perfect top guards for guitars. We call them guitar bibs in our shop. They're great to protect guitars during fretwork, bridge work, at the electronics bench from spitting solder shooting where you dont want it. I even save the little pieces to protect pegheads from a runaway nut file. They even make great protectors for clamping cauls. They're better than suede because that stuff still picks up all sorts of nasty stuff that can scratch up a customer guitar. They wipe perfectly clean with a little soap and water and dry in seconds. If you're not choosy about the color you can get them for less than 10 bucks, sometimes a lot less. A really huge one can often be found for 20 bucks or less and you can make lots of bibs out of them. Try it out and let's get the carpet off our benches! #guitarspecialist #guitarrepair #guitarrepairshop #guitartech #luthier #luthiersofinstagram #whatsonyourbench #guitar #fretwork #fendermustang #frets #techtips #shoptips"

330 likes, 47 comments - guitarspecialistinc on February 22, 2021: "I Hate Carpet!!! Today's shop tip is brought to you by a question from Grace @guelphguitarrepair. A couple of others have asked about this as well so I thought it … Continue reading