Feed

Stock response from Bambu about bed temps, brims, etc with a link to their wiki. I’m not going to pursue it but I’m also not going to use this plate anymore. It seemed like a consumable part the second I touched it and it’s performance has degraded since then, especially in the last 3 prints, each one worse than the prior. Anywho, could just be…

Read more

Thanks a lot Giuliano! Yes, I was at the call, very interesting by the way.

Jorge

Hello Jorge,

The behaviour of your guitar is normal, in Martin X braced guitars with the two asymmetric tonebars the two dipoles are very close in frequency around 350 Hertz, with the long dipole being usually the first to appear. If you’re interested, I had a talk on the group on this matter last weekend, it should be out soon…

Cheers,

Giuliano

Yea we would just want to put a slight gap in-between them, say .2mm, could even have some support materials in the middle for easy separation

I’ve got a parametric angled shim for fusion . Been meaning to upload to loothprint, I’ll try and do that this weekend 👍

Good call, I expect that will eliminate the layer lines to make the angle.

I will try that, and once improved, will do other degrees as well.